Incoming and outgoing line loops, leakage current, neutral voltage, zero-sequence current electrical parameter detection, switch status monitoring, load percentage detection; three-phase voltage, thre ...
When we use electricity in our daily home, we need three wires to be safe, which are the live wire, the neutral wire, and the ground wire. The ground wire is usually a yellow-green two-color wire. You ...
Today we are going to introduce the characteristics of Cold Shrink Cable Accessories. Before introducing the characteristics of cable accessories, let's briefly introduce what cable accessories are. C ...
drop out fuse burnout is a common type of fault in the operation of distribution networks, and its handling should start from three dimensions: fault location, failure analysis, and system repair. Thi ...
High Voltage Disconnect Switch is characterized by its obvious segmented gap and is mainly used to isolate high-voltage power supplies to ensure safe maintenance. It also has the ability to switch on ...
When a system fails, the three phases become asymmetrical, and the zero-sequence component with amplitude can be decomposed. Therefore, by detecting this zero-sequence current component, it can be kno ...
Wall Switch is an indispensable electrical device for every family and even every house. Although it is relatively small and the price is very cheap for the decoration of the whole house, people alway ...
The heat shrink cable terminal head of Cold Shrink Cable Accessories is made of PE material. When heating, it is necessary to use a heating tool to heat it so that it shrinks and tightly wraps around ...
Structural reliability design 1. Dual spring redundancy: Adopting a parallel structure of main and auxiliary springs (stiffness ratio of 2:1), it ensures that more than 80% of the pre tension force ca ...
High Voltage Disconnect Switch, this switch device, plays an important role in the power system. It is mainly used for "isolating power supply, switching operation, connecting and disconnecting small ...
The point difference between the neutral line and the PE line is called "zero point voltage". When the zero point voltage is higher than the allowable value of electronic information equipment, it wil ...
1. Water and electricity circuit transformation starts with the location of Wall Switch The following three aspects should be considered first when determining the location of switches and sockets: Fi ...
Low voltage Cold Shrink Cable Accessories can also be called low voltage cable terminal head. Low voltage is what we often call 0.6/1kv. There are two materials for low voltage cable heads, namely low ...
The "drop" feature of drop out fuse is its core functional design, but whether unexpected drops occur during operation is a key concern for operations personnel. This article analyzes the boundary con ...
Power-off sequence: first turn off the circuit breaker, then pull High Voltage Disconnect Switch Power-on sequence: first close the isolating switch, then close the circuit breaker (Mnemonic: "first t ...
Since the hospital is a special place, the power equipment must be timely, and irreversible accidents cannot be caused by the failure of a certain high and low voltage complete set of equipment. In or ...
Wall Switch is divided into 86 type, 118 type and 120 type. 86 switch socket The common module of 120 type is based on 1/3 standard, that is, on a standard 120mm×74mm panel installed vertically, three ...
Cold Shrink Cable Accessories, together with the cold shrink intermediate connection, belongs to the category of cold shrink cable accessories, which is a product with high customer demand. For the in ...
3、 Environmental interference effect Wind disturbance Wind force 8 (wind speed 17.2 m/s) generates aerodynamic torque on the melting tube: 𝑀𝑤=0.5⋅𝜌⋅𝑣²⋅𝐶𝑑⋅𝐴⋅𝐿 Among them, the air density is ρ=1 ...
When the "electric tiger" is showing its power, ordinary people can only tremble? Don't panic! High Voltage Disconnect Switch is like a "safety gate" in the circuit, which can cut off the power supply ...
There are many materials suitable for decorating Power distribution cabinet, including plates, glass, wallpaper, wall cloth and gypsum board, but different materials are suitable for different decorat ...
In the past, many hotels did not pay much attention to the installation of Wall Switch and sockets during the construction and renovation or renovation process, which caused many inconveniences for gu ...
1kv intermediate joint is also called 1kv intermediate connection joint. Generally speaking, it refers to Cold Shrink Cable Accessories intermediate joint, that is, the cable joint in the middle of th ...
The abnormal drop of drop out fuse is a typical fault in the operation and maintenance of the distribution network, which directly affects the reliability of power supply and equipment safety. This ar ...
We use cookies to collect information about how you use this site. We use this information to make the website work as well as possible and improve our services.